During the crushing process of the Jiankuang brand metal crusher, the fineness of the material can be adjusted as needed. From the three aspects of the metal crusher motor, air volume, and gap bolts, any one can be adjusted. If only one is adjusted, it does not meet expectations. To achieve the desired effect, several other adjustments can be selected at the same time. The general adjustment method is as follows. The detailed adjustment method can be found in the Jiankuang Metal Crusher Instruction Manual.
, fine granularity, maximum adjustment amount, minimum mesh adjustment amount. There is a direct relationship between fineness and output. Depending on the specific gravity of the material, the output will be large or small. The motor power and motor speed are also objective factors that affect the fineness.
, Jiankuang brand metal crusher is equipped with a fan powder selection device and an air volume regulator, which can adjust the air volume. The greater the air volume, the lower the fineness. The smaller the air volume, the higher the fineness. According to the required material fineness Granularity to determine the size of the air volume to be adjusted.
. There is a fineness limit bolt inside the metal crusher. After loosening the limit bolt, adjust the bolt gap up and down. Move upward, the finer the grinding fineness, adjust downward to coarser the grinding fineness. Adjust to the desired After the fineness standard is required, the bolt position can be determined nationally, and then the metal crusher will be inspected before starting up and prepared for production.
News