河南建矿机械设备有限公司

Impact crusher is widely used for medium crushing and fine crushing (sand making) of various hard and brittle materials such as rocks, abrasives, refractory materials, cement clinker, quartz stone, iron ore, concrete aggregates, etc. It is suitable for construction Sand and gravel are suitable for road construction. The impact crusher has a simple structure, low price, smooth operation, high efficiency and energy saving. The material in the impeller and vortex crushing chamber is self-lining, which greatly reduces the cost of wear parts and the workload of maintenance. The impact crusher effectively solves the problem of glass and other raw materials. The clever internal air flow self-circulation eliminates the problem of iron contamination during the crushing process and the stuck steel problem during the steel slag crushing process. Factors Affecting Production Capacity
Generally speaking, there are many factors that affect the production capacity of impact crushers. Generally speaking, there are factors in this regard. Below I will describe these factors and propose corresponding solutions.
.Hardness of the material: The harder the material, the more difficult it is to make sand, and the more severe the wear and tear on the equipment. The sand making speed is slow and the capacity is low, so we need to pay more attention to the selection of materials.
.Material composition: The more fine powder the material contains before the impact crusher, the more it will affect sand production, because these fine powders are easy to adhere and affect transportation, so materials with a large content of fine powder should be screened in advance. , screen out the fine powder as much as possible from the material to avoid affecting the normal operation of the impact crusher.
.The fineness of the material crushed by the impact crusher: The fineness requirement is high, that is, the finer the material required for sand making, the smaller the sand making capacity. This aspect depends on specific requirements. If there is no special Requirements, generally set the fineness of the material to medium fine.
.Viscosity of the material: The greater the viscosity of the material, the easier it is to adhere. Materials with high viscosity will adhere to the inner wall of the sand making chamber in the Red Star Impact Crusher. If it cannot be cleaned in time, it will affect The working efficiency of the impact crusher may even affect the normal operation of the impact crusher in severe cases. Therefore, when selecting materials, we must pay attention to the fact that the viscosity of the material is not too high.
.Material humidity: When the material contains a large amount of moisture, the material will easily adhere to the impact crusher and cause blockage during the unloading and conveying process, resulting in a reduction in sand making capacity. To solve this problem, first of all, the humidity of the material must be strictly controlled when selecting the material. If the humidity of the selected material is too high, sunlight or air drying can be used to reduce the percentage of moisture in the material.